![]() ![]() If you are ‘keying’ your radio (indicated by the illumination of the TX light) without transmitting audio, check these: If you’re not on a Listen-Only channel (see above), there are three likely causes of this: Improper mic placement/orientation, swapped PTTs, and hand mic incompatibility. If your coax looks flattened, kinked, frayed, or worn, replace it!įor more information, please read our Installation Tech Guide. ![]() When tie wrapping the coax to the frame, do not crush the coax. ![]() They create noise and if the coax is too close to the MSD, transmitting can even power the vehicle off! Never run coax or power cables near MSD or igniton equipment. RF can bleed over when transmitting, putting noise into the system. Mounting the antenna to a corner triangle tab and using a no ground plane antenna will work best.ĭo not run radio coax and intercom helmet cables in the same wire loom. The intersection of two tubes can also act as a ground plane. No Roof - Pick a spot in the middle of the car. Roof Racks - Mount the antenna at the highest point of the rack. A metal roof with an antenna mounted in the center with no obstructions (roof rack, light bar) 18" in every direction provides the farthest range.
0 Comments
Leave a Reply. |